Memory- Cancellation Of All Measurements; Pc-Link Functions; Installation And Data Transmission - Microlife BP 3AC1-1 PC Mode D'emploi

1
MR
30 sets of stored measurements – MR30: Value of the last measurement – MR29: Value of the measurement before MR 30
5.8.Memory– cancellation of all measurements
Attention!
Before you delete all readings stored in the memory, make sure you will
not need refer to the readings at a later date.
In order to delete all stored readings, depress the «M» button for at least
7 seconds, the display will show the symbol «CL» and 3 short beep
sounds will be heard to indicate deletion of stored readings.
Note:
If your last stored measurement was taken in the MAM mode, you will
see the « » symbol approximately 3 seconds during the deletion
procedure. (The display will show this symbol during deletion of all stored
measurements, if the last measurement is taken in the MAM mode).

6. PC-Link Functions

This device can be used in connection with a persoanl computer (PC) running the
Microlife Blood Pressure Analyser (BPA) software. The memory data can be
transferred to the PC by connecting the monitor via cable with the PC.

6.1. Installation and Data Transmission

a) Insert CD into CD ROM drive of your PC. The installation will
start automatically. If not, please click on «SETUP.EXE»
b) Connect the monitor via cable with the PC – no need
to switch the device on. Three horizontal bars will
appear on the display and last for 3 seconds.
c) The bars will then flash to indicate that the connection between
computer and device is successfully made. As long as the cable is
plugged, the bars will keep flashing and buttons are disabled.
During the connection, the device is completly controlled by the
computer. Please refer to the «help» file for software instructions.
1
mmHg
MR
MR
mmHg
mmHg
MR
mmHg
MR
M
11