Tripp-Lite B007-008 Manuel D'utilisation page 16

• F2 Scan:
Pressing [F2] initiates the Quick View Scan Mode, in which the OSD cycles through all
the ports that have been selected for Quick View Scanning (see F4, below), and displays
each one for the amount of time set with the Set Scan Duration function (see F6, below).
When you want to stop at a particular location, press any key to stop scanning.
Note: 1. If the scanning stops on an empty port, or one where the computer is attached
but is powered Off, the monitor screen will be blank, and the mouse and
keyboard will have no effect. To recover, key in the Hot Key sequence (see
Hot Key Selection, above), for any Port ID that has an active PC attached.
2. As the OSD cycles through the selected ports, an S appears in front of the Port
ID display as each computer is accessed to indicate that the computer is being
accessed under Quick View Scan Mode.
• F3 List:
Pressing [F3] brings up a submenu that lets you control the ports which the OSD lists:
Choice
All
QView
Powered On +
QView
QView + Name
Name
Powered On
To make a choice, move the Highlight Bar to your selection, then press [Enter]. The icon
that appears before the choice indicates the current selection.
Note: 1. You can access any port on any list by using the Navigation Keys to move the
Highlight Bar to it, then pressing [Enter].
2. If you select a port that does not have a PC attached to it, or if the attached PC
is powered Off, the OSD will still switch to it, and will not show an error.
Lists the Port ID Numbers and Names (if names have been specified,
see F5) of all the ports in the installation.
Lists only the ports that have been selected for Quick View scanning
(see F4 below).
Lists only the ports that have been selected for Quick View scanning
(see F4 below) and that have their attached PC Powered On.
Lists only the ports that have been selected for Quick View Scanning
(see F4 below), and have been assigned names (see F5 below).
Lists only the ports that have been assigned names (see F5 below).
Lists only the ports that have their attached PCs powered on.
- 14 -
Meaning