Inserting The Drivepack Into The E-Bike - FAZUA RIDE 50 TRAIL Notice Originale

Original instructions | English
3. Place the BATTERY with the connecting contact first on the battery holder of
the DRIVEPACK.
A
4. Carefully insert the BATTERY as far as possible into the battery holder.
The BATTERY locks in place automatically when inserted correctly. If the
BATTERY does not lock, repeat the procedure. Do not use the drive system if
the BATTERY cannot be locked. If the unlocked BATTERY falls out of the e-bike
holder while riding, this can lead to an accident/fall and damage the BATTERY.
4.1.2

Inserting the DRIVEPACK into the e-bike

→
You can find detailed information here
e-bike".
1. Place the DRIVEPACK with the interface for the BOTTOM BRACKET in front of the
corresponding interface on the BOTTOM BRACKET.
2. Swing the upper end of the DRIVEPACK into the down tube of the e-bike.
The DRIVEPACK is locked automatically when the two interfaces on the
DRIVEPACK and the BOTTOM BRACKET interlock correctly and the DRIVEPACK
engages fully in the retainer on the down tube.
in Chapter 16.1 "Inserting the DRIVEPACK into the
A
D
A
B B
87