Ending Charging Process; Charging Process - FAZUA RIDE 50 TRAIL Notice Originale

Original instructions | US-English
3. Plug the power plug [E.5] into a suitable wall outlet to establish the power
connection.
The charging process starts automatically after connection to the mains.

27.7.2 Ending charging process

1. Then disconnect the CHARGER from the power grid by pulling the mains plug
[E.5] out of the socket.
2. Disconnect the CHARGER from the BATTERY by pulling the charging plug [E.3]
out of the charging socket [D.3] on the BATTERY.
3. Fold down the cover flap again to close off the charging socket [D.3].
Always make sure the cover flap closes off the charging socket securely when
the BATTERY is not being charged to prevent moisture, dirt, etc. from entering
the charging socket and damaging the BATTERY.
4. Install the DRIVEPACK with BATTERY correctly on the e-bike.

27.8 Charging process

The charging process begins as soon as you have connected the charging plug
[E.3] on your CHARGER to the charging socket [D.3] on the BATTERY and connected
the CHARGER to the power supply.
The flashing LEDs on the charge level indicator [D.4] of the BATTERY indicate that
the BATTERY is charging.
D.3 E.3
129