Remote 14 Receptacle Information; Connecting Remote Control; Remote 10 Receptacle Functions For Spoolmatic 15A/30A - Miller SHOPMATE 300 DX Mode D'emploi

3-8. Remote 14 Receptacle Information

24 VOLTS AC
REMOTE
OUTPUT
CONTROL
A/V
AMPERAGE
VOLTAGE
GND
*The remaining sockets are not used.

3-9. Connecting Remote Control

3-10. Remote 10 Receptacle Functions For Spoolmatic 15A/30A

.
See spool gun Owner's Manual for spool gun operation.
Socket*
A 24 volts ac. Protected by circuit breaker CB1.
B Contact closure to A completes 24 volts ac contactor control circuit.
C Output to remote control; +10 volts dc in MIG mode.
D Remote control circuit common.
E 0 to +10 volts dc input command signal from remote control.
M CC/CV select
F Current feedback; +1 volt dc per 100 amperes.
H Voltage feedback; +1 volt dc per 10 arc volts.
G Circuit common for 24 volts ac circuit.
A J
K
I
B
C L N
H
M
D G
F
E
OR
Socket
B, C
D, G
E
F
H
Socket Information
!
1
1
Connect remote control to RC14.
OR
Socket Information
Motor control voltage to spool gun motor.
Trigger closure.
Wire feed speed command reference; +8 volts dc.
Wire feed speed command signal.
Connects motor speed control counterclockwise to circuit
common through a small resistance allowing motor to run at
0 setting of motor speed control.
Turn off power before con-
necting to Remote 14 recep-
tacle.
Remote 14 Receptacle RC14
Ref. S-0004-A / S-0750
OM-225 757 Page 15