Maintenance; Maintenance Plan - Mennekes AMTRON Start Instructions D'installation

8 Maintenance

Danger
Risk of death resulting from improper maintenance /
repair.
There is a risk of injury for persons performing tasks for
which they are neither qualified nor have received
appropriate training.
 The maintenance / repair of the device may be
performed only by persons who are familiar with this
task, have been instructed with regard to the
associated hazards and who possess the necessary
qualifications.
 All technical safety conditions have to be satisfied prior
to performing maintenance / repairs.
Danger
Risk of death by electric shock!
Components have voltage applied.
Contact with current conducting parts results in an electric
shock, burns or death.
When working with the electrical system, the following
points must be observed:
 Disconnect device from voltage.
 Secure device from being turned back on.
 Ensure that no voltage is applied.
 Earth and short-circuit the unit.
 Cover neighbouring componets that are under voltage
and secure the danger area.

8.1 Maintenance plan

Carry out the following maintenance work at the specified
intervals.
21
Maintenance interval every 6 months (biannually)
Part / component
Enclosure
Front panel
Switching and safety
devices
Maintenance interval every four years
In addition, carry out all maintenance specified in
"Maintenance interval every 6 months (biannually)".
Part / component
Cable connections
and connectors
Charging station
System check
Maintenance work
Visual inspection for defects or
damage.
Check the device for secure
fastening.
Clean the outside of the enclosure
with damp cloth.
Visual inspection for defects or
damage.
Visual inspection for defects or
damage.
Check the function of the circuit
breaker (CB).
See Chapter 7.3.3 on page 19.
Maintenance work
Check for firm seat
Visual inspection for defects or
damage.
Visual inspection for defects or
damage.
Check function
Check the system
 See Chapter 6.2.1 on page
16.