Do not use the Palm with management software versions earlier than V3.00.
•
•
The virtual code hardware programming key can only be used with PGM486 firmware ver-
sione 2.0. If you have an old Palm and you wish to use this function you will have to update
the appliance by replacing the microchip and the internal memory.
The references to the receiver with display are for products which feature firmware version
•
2.0. or greater (the firmware version is shown at startup).
•
To use all of the following functions you must have both the upgraded version of the Palm
as well as the upgraded version of the receiver. Connecting products with different versions
will cause you to loose certain functions.The possible combinations and relative limitations
are as follows:
PGM486_V20 and receiver with an old firmware version
a.
PIN code security functions are not available on the receiver.
b.
The add transmitter function is available on the receiver but not on the palm. You will
not be able to program transmitters for this function.
c.
Uses the PC program from version V3.00 onwards.
PGM486_V20 and receiver with firmware version V2.0
a.
All the functions described in this instruction manual are available.
b.
Uses the PC program from version V3.00 onwards.
•
We strongly advise you not to use palm devices with different software versions in the same
installation: if this is inevitable, disable the security functions for the PGM486.
The previous versions use the PIN differently and this can cause the error "Er3" if they are
used on installation created with a new palm. To recover operational conditions for the receiver
which gave the "Er3" error you will have to use the original palm (or another with the same
firmware version that has the same PIN code number).
! ! ! A T T E N T I O N ! ! !
COMPATABILITY WITH EARLIER VERSIONS
17