Mustang Survival MD3153 V.F.I. Manuel Du Propriétaire page 21

Repack the Inflatable PFD as outlined in the Repacking section
(see Repacking, p. 13).
ii) oral Inflation Valve Test: To check the oral inflation valve, fully
inflate the Inflatable PFD using the oral inflator and hold valve
under water. If bubbles appear, deflate and re-inflate to test
again. Should the leak persist, take your Inflatable PFD to your
Mustang dealer for evaluation and/or servicing.
CaUtion: to avoid accidental inflation, don't allow the
water to contact the hydrostatic inflator.
iii) P erform a thorough visual examination. (see Readiness
Checklist, p. 4).
Perform these tests more often if exposed to potential damage
or used in extreme conditions.
3) After each Inflation - Re-arm the Inflatable PFD. (see Re-arming
Your PFD, p. 9).
4) Annually - Perform the following at the beginning of each boating
season, after inflation, or whenever the integrity of the Inflatable
PFD is in doubt:
i) C heck all components for dirt or corrosion. Clean or replace, as
necessary. (see Readiness Checklist, p. 4).
ii) Visually examine your Inflatable PFD for damage or excessive
abrasion, wear, tear or contamination. Particular attention
must be paid to the stitching, straps and hardware. If in doubt,
send it to your Mustang dealer for evaluation and/or servicing.
iii) Perform the oral Inflation Valve Test: See the oral Inflation
Valve Test in the every Two (2) Months Care and Maintenance
Instructions section.
iv) Perform the leak Test. See the leak Test in the every Two (2)
Months Care and Maintenance Instructions section.
v) ensure the current date is not past the date on the inflator. If it
is, replace the inflator (see Re-arming Your PFD, p. 9).
vi) ensure the single point status indicator is green (Fig. 2).
vii) Record as an "Annual" inspection in permanent ink on the
Care and Storage label, in the Date Maintained column.
Repack the Inflatable PFD as outlined in the Repacking section (see
Repacking, p. 13).
18