Mustang Survival MD3153 V.F.I. Manuel Du Propriétaire page 15

Figure 15
9) While pressing FIRMlY onto the inflator body, turn the BlACk
locking ring clockwise into the locked position (Fig. 17). Pull on
the cap to make sure it has locked onto the inflator body.
Figure 17
Lanyard
Black
Locking
Ring
10) Check: To see that the single point status indicator on the cap is
green, the pull to inflate lanyard is present and that the locking
ring is locked. Turn the cell and cover right-side out, returning to
normal state.
11) As a final check, inflate the life jacket through the oral tube and
make sure it stays inflated at least overnight.
12) With the dust cap in the top of the oral tube, gently squeeze the
inflatable life jacket until all the air has been expelled (Fig 6). Do
not wring or twist it. Replace the oral tube dust cap back in its
stowed position (Fig 7).
13) If your inflatable PFD has a black inflator cap cover, position the
protective cap over the inflator body so that the single point
status indicator is visible through the inflator cap cover window
(Fig 17A).
Figure 16
Figure 17a
Inflator Cap
Cover
Single Point
Status Indicator
Inflator Cap
Cover Window
12