Installing The Slz 63; Installing The Motor Assembly - RK Rose+Krieger SLZ 63 KG P PL Notice D'assemblage

7.4 Installing the SLZ 63 P

7.4.1 Installing the motor assembly

The housing is designed to attach a motor with or without gears. Correct configuration of the
drive will prevent this electric cylinder causing danger.
Motors or motor/gear combinations recommended by RK Rose+Krieger GmbH for this electric
cylinder are installed using a motor adapter. This matched combination ensures that the elements
work together correctly.
Before starting installation, ensure that the supply to the drive motor has been isolated.
Combinations of motors/gears/motor adapters which differ from those recommended by
RK Rose+Krieger GmbH are installed at the customer's own risk.
The screw tightening torques can be found in the table in chapter 7.5. Spacer washer, adaptor,
lock washer, washer and fastening screw are only designed for their respective drive.
1. Fit the key to the drive pin.
2. Push on the spacer washer above the key on the
drive pin until it touches the base.
3. Push the toothed washer on until it touches
the spacer washer on the drive pin.
4. Fit the washer into the toothed washer.
5. Screw the washer using the hexagon
socket screw onto the drive pin.
6. Center the adaptor onto the motor flange
and screw up.
7. Life phases
65