Conditions At The Installation Site; Assembling The Linear Unit On The Substrate; Assembling The Linear Unit With Clamping Bars - RK Rose+Krieger RK MonoLine R Manuel D'utilisation

5.2 Conditions at the installation site

5.3 Assembling the linear unit on the substrate

5.3.1 Assembling the linear unit with clamping bars

Applicable to
Inserting clamping bars
Fig. 12: Inserting clamping bars
26.03.2019
Assembling the linear unit on the substrate > Assembling the linear unit with clamping bars
The following conditions must be met at the linear unit's installation
site:
n The substrate and the mounting surfaces are designed for
static and dynamic loads.
The installation site has a smooth ground surface, is free from
n
vibrations, oscillations or shocks, and is moisture-resistant.
n Sufficient lighting is available.
n The installation site is clean and dry, and free from dust and
objects.
n The atmosphere must be free from solvents.
n All of the connections required on site are available.
Room temperature: 0 - 60°C
n
Relative humidity: 0 - 85%
n
n Temperatures below the dew point are not permitted.
Version
Size
Personal:
Schutzausrüstung:
Prerequisite:
n The substrate must be prepared for the linear unit being fixed
to it.
1. Insert clamping bars (Fig. 12/1) into the slot of the guide pro-
file.
Linear unit RK MonoLine R/RK MonoLine Z
RK MonoLine R, Z
40/60/80/120
n Assembly staff
Protective clothing
n
n Protective gloves
n Safety shoes
Depending on the length of the linear unit, 2 or
more clamping bars must be inserted on each
side of the guide profile (Fig. 12/2).
Assembly
93