Remote Control; Inserting Batteries; Troubleshooting - Sonnenkonig MERKUR 20020112 Mode D'emploi

Remote Control

1 Power button: Turn the heater off.
2 Down button: Decrease temperature, timer and level.
3 Up button: Increase temperature, timer and level.
4 Level button: Use to select one of four heat levels (L1-L4). Press
the Level button then use the Up and Down buttons (buttons 2
and 3) to increase or decrease the heating level.
5 Timer button: Use to set the duration of hours that the heater
will be in operation. Press the Timer button and T0 will display.
Use the Up and Down buttons (buttons 2 and 3) to adjust the
number of hours you would like to set.
Noted: All sonnenkönig heaters and their remote controls have the same
frequency, so it is possible to control several heaters with just one remote.

Inserting Batteries

Insert 2 AAA alkaline batteries into your remote control.
1. Turn the remote control over so that the rear is facing you and
remove the battery cover. Insert the batteries in accordance with
the instructions and ensure the polarity is correct.
2. Change the batteries in the same way as described above.
NOTICE:
1. Replace old batteries with batteries of the same type. Otherwise your heater may not func-
tion properly.
2. If the heater will not be used for long periods, remove the batteries to prevent leakage as
this may damage the remote control.
3. Do not allow water or liquid to enter the remote control.
Caution:
The heater should be switched OFF and unplugged from the electrical connection if the appli-
ance will not be operated for a long period of time, if cleaning or maintenance is being con-
ducted, or if you want to change the location of the heater.
Periodic inspection and removal of any accumulated dirt will ensure that the heater can be
operated safely.

5. Troubleshooting

1 Check if the power cord is plugged into an electrical outlet, if not, plug in.
2 Check if electricity to the main fuse is working
3 Check to see it the thermostat knob to the ON position
4 Check the thermostat setting, the heater may be off because it has reached the desired
temperature setting.
52