Alliance Laundry Systems FLW1548C SVG Guide De L'utilisateur page 27

Washer Symptom
Er, OF on digital display
Er, PS on digital display
Er, dU on digital display
Er, dl on digital display
Er, ub on digital display
PF on digital display
Er, SL on digital display
Sr, cycle time remaining on digital display
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
Possible/Cause Solution
• This code indicates the washer has filled to the overflow level.
• The machine will begin to attempt to pump water out if the door
is closed and locked.
• Foreign object trap in pump may be clogged. Clean the trap. Re-
fer to Maintenance section.
• If the code does not clear, unplug the machine and call for serv-
ice.
• The control has detected trouble sensing the water fill level.
• Unplug the machine and call for service.
• The control senses that the door will not unlock.
• Unplug the machine for three minutes to unlock the door.
• If the code appears again, call for service.
• This code indicates that the door has not locked.
• Make sure the door is closed all the way and try to start the
cycle.
• Open the door or unplug the machine to clear the code.
• If this code continues, call for service.
• This code indicates that the wash load was unbalanced.
• The unbalanced load may have limited the spin speed.
• Be sure to use proper load sizes.
• Open the door or press the Power/Cancel keypad to clear this
code.
• This code will be displayed if the control was in Delay Start
Mode when a power failure occurred.
• The delayed start will be canceled.
• Press the Power/Cancel Pad to clear the code.
• This code will be displayed after a cycle for one minute, or until
the Power/Cancel keypad is pressed, and indicates an oversuds-
ing condition.
• Laundry load may be oversudsing. Make sure you are using low
sudsing, high efficiency (HE) detergent. If using non-HE deter-
gent, use only 1/2 of the detergent manufacturer's recommen-
ded amount.
• Laundry load may be overloaded. Make sure you are using proper
load sizes.
• The control has detected an oversudsing condition and is run-
ning a special routine to remove the excess suds.
27
Troubleshooting
Part No. 806630EN