Troubleshooting - Alliance Laundry Systems FLW1548C SVG Guide De L'utilisateur

Troubleshooting

Try these troubleshooting tips before making a service call. They
may save you time and money.
Washer Symptom
Won't Fill
Won't Start
Won't Spin/Tumble
Stops/Pauses During Cycle
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
Possible/Cause Solution
• Make sure power cord is plugged all the way into the electrical
outlet.
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Press Start/Pause button to start washer.
• Make sure that the controls are properly set.
• Make sure that the loading door is closed tightly.
• Check the laundry room fuse or circuit breaker.
• Clean the screens in the water mixing valve and the filter
screens located at the faucet end of the fill hoses. (Owner is
responsible for service calls regarding cleaning of the screens.)
• Make sure that the loading door is closed tightly.
• Press Start/Pause button to start washer.
• Make sure power cord is plugged all the way into the electrical
outlet.
• Make sure that the controls are properly set.
• Check the laundry room fuse or circuit breaker.
• Make sure door latch is properly adjusted relative to door lock.
• You will not be able to press the Start/ Pause button to start a
cycle until five seconds after turning on the washer. A status
light will flash during this warm-up period.
• Make sure that the loading door is closed tightly.
• Press Start/Pause button to start washer.
• Make sure power cord is plugged all the way into the electrical
outlet.
• Make sure that the controls are properly set.
• Check the laundry room fuse or circuit breaker.
• Broken drive belt. Call the service person.
• Foreign object trap in pump may be clogged. Clean the trap. Re-
fer to Maintenance section.
• Pauses are part of the washer' s normal operation.
• Check the laundry room fuse or circuit breaker.
• Wash load may be unbalanced. Washer will stop and then re-
start spin automatically. If the washer is severely unbalanced,
press the Start/Pause button and redistribute the load.
24
Troubleshooting
Table continues...
Part No. 806630EN