Alliance Laundry Systems FLW1548C SVG Guide De L'utilisateur page 25

Washer Symptom
Won't Drain
Water Leaks
Too Many Soap Suds
Vibrates/Moves Slightly
Is Noisy
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
Possible/Cause Solution
• Make sure drain hose is not kinked or twisted.
• Make sure drain hose is not clogged.
• Make sure drain receptacle is not clogged.
• Refer to the Installation instructions to make sure that the
drain hose has been properly installed.
• Foreign object trap in pump may be clogged. Clean the trap. Re-
fer to Maintenance section.
• Check that fill hoses are properly installed on the faucets and
the washer' s water mixing valve.
• Check the condition of the fill hoses. Replace fill hoses every five
years.
• Check the condition of the rubber door gasket for tears or
holes.
• Make sure drain receptacle is not clogged.
• Check laundry room plumbing.
• Laundry load may be oversudsing. Make sure you are using low-
sudsing, high efficiency (HE) detergent.
• Laundry load may be overloaded. Make sure you are using proper
load sizes.
• Make sure outside perimeter of the door glass where seal con-
tacts glass is clean.
• Laundry load may be oversudsing. Make sure you are using low-
sudsing, high efficiency (HE) detergent.
• Make sure you are using the amount of detergent recommen-
ded on the detergent' s label. If using non-HE detergent, use only
1/2 of the detergent manufacturer's recommended amount.
• Laundry load may be overloaded. Make sure you are using proper
load sizes.
• Make sure washer is level. Uneven leveling can cause vibration.
• Make sure shipping materials have been removed.
• Make sure washer is installed on a solid, sturdy and level floor.
The washer should not be installed on carpeting, soft tile or
other weakly supported structures.
• Make sure rubber feet are installed on all four leveling legs. Refer
to Position and Level the washer.
• Try placing the washer near a corner of the room or near an ex-
ternal structural support wall.
• Make sure washer is level. Uneven leveling can cause vibration.
• Some sounds may be a part of normal operation for a frontload
washer, such as clicking noise when door locks and unlocks, and
clicking noise from balance ring during agitate part of cycle.
• When rotating the tub slowly you will hear the balance balls click
together. This noise is normal and does not require a service
call.
25
Troubleshooting
Table continues...
Part No. 806630EN