Preparation And Operation; Connecting Up The Prismaconnect Module - Lowenstein Medical prismaCONNECT WM 100 MC Mode D'emploi

4 Preparation and operation

4 Preparation and operation
4.1 Connecting up the prismaCONNECT
34 EN prismaCONNECT
module
Only connect up the therapy devices and modules permitted in
accordance with these instructions for use. Devices connected up
to the prismaCONNECT module's LAN port must comply with the
respective product standard. Position non-medical devices outside
of the patient's immediate vicinity.
1. Place the therapy device on a level surface (e.g., a table).
2. Switch on the therapy device (see instructions for use of the
therapy device).
You can also connect the module when the therapy device is
switched off. Then switch on the therapy device.
3. Open the system interface cover on the right side of the
therapy device.