Installation Of No-Light Cover (Sold Separately) - Luminance Brands CF605BQ00 Mode D'emploi

9. Installation of No-Light Cover
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box or circuit breaker panel before
wiring. All wiring must be in accordance with National
and Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
IMPORTANT: Disconnection of the LED Light
Fixture Assembly Terminals from the Fan Motor
Housing Terminals prior to Assembly of the
No-Light Cover, is necessary.
NOTE: If Shade is installed on the Ceiling Fan,
Remove the Shade as follows:
9.1
Remove and retain the Shade from the opening of
the Light Kit Adapter by turning the Shade Counter-
Clockwise (Figure 43) .
NOTE: Store the Shade in a safe place for future
use, if needed.
9.2
Remove and Retain One of the #8-32 x 10mm Pan
Head Screws from the LED Light Fixture Assembly
(Figure 44) .
Loosen the Two #8-32 x 10mm Pan Head Screws in the
Keyhole Slots (Figure 44) .
Rotate the LED Light Fixture Assembly Counter-
Clockwise to disengage the Fixture from the Two
loosened Screws .
Carefully let the LED Light Fixture Assembly hang to
disengage the terminals .
(Sold Separately)
LIGHT KIT
ADAPTER
SHADE
Figure 43
LED LIGHT
FIXTURE
ASSEMBLY TURN LED
COUNTER-CLOCKWISE
REMOVE ONE #8-32 x 10 mm
SERRATED PAN HEAD SCREW
Figure 44
Please contact 1-800-777-4440 for further assistance
27
TURN SHADE
COUNTER-CLOCKWISE
LOOSEN TWO #8-32 x 10 mm
SERRATED PAN HEAD SCREWS
luminancebrands.com
U.L. Model No.: CF605