Disassemble The Led Light Fixture Assembly For The No-Light Cover Installation Only - Luminance Brands Kathy Ireland Home HIGHPOINTE LED Manuel Du Propriétaire

7. Disassemble the LED Light Fixture Assembly
for the No-Light Cover Installation Only
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring
must be in accordance with National and Local codes
and the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
7.1
Remove and retain the Glass from the opening of the
Lower Housing by turning the Glass counter-clockwise
(Figure 31).
NOTE: Store the Glass in a safe place for future use,
if needed.
7.2
Remove and retain the three #8-32 x 3/8" Pan Head
Screws from the Lower Housing to detach the LED Light
Fixture Assembly (Figure 32).
NOTE: Store the #8-32 x 3/8" Pan Head Screws in a
safe place for future use, if needed.
Figure 31
LED LIGHT FIXTURE
ASSEMBLY
LOWER HOUSING
#8-32 x 1/4" PAN HEAD SCREWS
WITH LOCKWASHERS (3)
#8-32 x 3/8" PAN HEAD
SCREWS (3)
Figure 32
20
LOWER
HOUSING
GLASS
U.L. Model No.: CF205L-1