Troubleshooting - LawnMaster NPTBSP2609A Manuel D'utilisation

TROUBLESHOOTING

If your brush cutter does not appear to operate properly, follow the instructions below. If this does not
solve the problem, please contact your local repair agent.
WARNING
Before proceeding, shut off the engine, wait for all moving parts to stop, and remove the battery pack.
Failure to follow these instructions can result in serious personal injury or property damage.
PROBLEM
The engine does not
start.
POSSIBLE CAUSE
The battery is not secure.
No spark.
No fuel.
35
SOLUTION
Insert the battery correctly. Ensure the
battery is fully charged.
Clean or replace the spark plug. Reset
the spark plug gap. Refer to the Spark
Plug Replacement section in this
manual.
fuel tank. Push the primer bulb until the
bulb is full of fuel. If the bulb does not
blocked. Contact an authorized service
item.
Remove the spark plug referring to the
Spark Plug Replacement section in
this manual. Press the start button 5
to 10 times. Then leave the cutter with
the spark plug removed for about 30
minutes. After 30 minutes, replace the
spark plug referring to the Spark Plug
Replacement section. Then re-start the
engine. If the engine still does not start,
contact an authorized service dealer.
Air Filter section in this manual.