LawnMaster NPTBSP2609A Manuel D'utilisation page 24

Masquer les pouces Voir aussi pour NPTBSP2609A:

Table des Matières

Les langues disponibles

OPERATION

engage the throttle safety and the throttle trigger to start the cutter (Fig. 28 - 31). The choke lever

will automatically switch to RUN position.

NOTE: If the engine does not start, repeat step 5 until the engine starts.

NOTE: This 2-cycle brush cutter is equipped with an automatic choke reset. The user must switch the

choke lever to CHOKE position for cold starts. As soon as the throttle trigger is engaged, the choke

lever will automatically switch to the RUN position.

NOTE: After the engine starts and runs, release the throttle trigger and allow the cutter to warm up at

idle for several minutes.

engage the throttle safety and the throttle trigger to start the cutter.

Fig. 28

Fig. 30

START

Fig. 29

Fig. 31

Table des Matières

Chapitres

Table des Matières