Installation And Electrical Connection - salmson SIRIUX Série Manuel D'installation Et Mise En Service

Symbol Meaning
The double pump runs in efficiency-optimised peak load operation
(master + slave).
Double pump running in main/standby mode
(master or slave)
Appears on pumps with certain IF Modules (see documentation of IF
Modules) if a signal (sign) is sent from the building management system
to the pump.
The pump is set in the "US units" mode.
Fault-tolerant error matrix activated.
Heating operating mode (for faults, see Chapter 10)
Fault-tolerant error matrix deactivated.
Air-conditioning operating mode (for faults, see Chapter 10)
Menu structure: There are three menu levels. The levels below the indication of
the basic settings are always accessed from level 1 by pressing the control but-
ton for different lengths of time.
• Level 1 - Status indication (indication of the operating status)
• Level 2 - Operation menu (setting the basic functions):
• Press the control button for longer than 1 second
• Level 3 - Options menu (further settings):
• Press the control button for longer than 6 seconds
NOTE: After 30 s without any entry being made, the display jumps back to level
1 (indication of the operating status). Temporary, non-acknowledged modifi-
cations are discarded.

7 Installation and electrical connection

DANGER! Risk of fatal injury!
Incorrect installation and inexpert electrical connection can pose a risk of
fatal injury. Danger from electrical current must be ruled out.
• Installation and electrical connection may only be carried out by qualified
personnel and in accordance with the applicable regulations!
• Accident prevention regulations must be observed!
• Comply with the regulations of the local power supply company!
Pumps with pre-assembled cable:
• Never pull on the pump cable!
• Do not kink the cable!
• Do not place any objects on the cable!
Installation and operating instructions Siriux/Siriux-D
English
63