Practicing - Roland VT-12 Mode D'emploi

Masquer les pouces Voir aussi pour VT-12:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 52

Practicing

The VT-12 provides two practice modes: Warm-up mode and Exercise mode. Each mode contains
tracks (p. 3) that are ideal for the corresponding type of practice.
Since the sound you produce while practicing is automatically recorded to the relevant tracks, you
can listen to it afterwards (Review function).
Warm-up mode
Exercise mode
MEMO
For more about practicing, you can also refer to the separate "Practice Guide. "
It provides helpful advice on vocalizing and singing, and tips for practicing with each track.
* Each time a track is played back, a new recording is started. If you play back a track that was
previously recorded, the sound that was recorded on that track will be overwritten. If you stop
the playback of a track within 3 seconds after the moment it was started, sound will not be
recorded on that track.
1
Select a practice mode .
The button of the selected mode will light.
2
Use the [
] [
to select a track .
MEMO
• By repeatedly pressing the button
for the mode you selected, you can
switch between preset tracks and
user tracks.
• If not even one user track has been
recorded, the display will indicate "U--. "
• For details on the tracks, refer to the
separate "Track List. "
3
Press the [
The track will play back, and recording of the
sound will begin.
4
Sing along with the track .
As you sing, pay attention to your own pitch and
to the pitches of the track that's playing.
Preset tracks and user tracks
The VT-12 contains built-in preset tracks (001–) for each mode. You can also record tracks
via the REC IN jack and use them as user tracks (U01–U10). (User tracks are common to both
modes.)
This contains tracks for vocalization practice that will warm up your voice.
This contains tracks for improving your vocal technique, such as enhancing your
breathing control and broadening your vocal range.
] buttons
] button .
6
Press the [REVIEW]
button .
The recorded sound will begin playing.
If nothing is recorded, the display will
indicate "---. "
MEMO
Depending on the track you've
selected, you may be able to turn
on/off the sounding of the vocals of
the track by pressing the [REVIEW]
button during playback of the
recorded sound.
5
Press the [
Track playback and sound recording will stop.
Lit:
Pitches you sing
Blinking: Pitches of the track
* With some tracks (User tracks and certain
Preset tracks), the unit will not indicate
the pitches by blinking.
] button .
ENG
DEU
FRA
ITA
ESL
POR
NLD
13

Publicité

Table des Matières
loading

Table des Matières