Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY STEP 1
PART
TYPE
A
UPRIGHT GUIDE BOLT
B
BOLT
C
FLAT WASHER
D
SPRING WASHER
4
1
A
C
D
B
10
HARDWARE FOR STEP 1
DESCRIPTION
M8X1.25PX11L-D10X18.5L
M8X1.25PX80L-20L
8.4X15.5X1.6T
8.2X15.4X2.0T
3
2
B
D
C
A
3
A
Cut the yellow banding straps and lift the running
deck upward from the rear to remove all contents from
QTY
underneath the running deck.
2
B
Open HARDWARE FOR STEP 1.
8
C
Insert UPRIGHT GUIDE BOLT (A) into MAIN FRAME
8
BRACKET (1) and tighen.
8
D
Pull the CONSOLE CABLE (2) away from the treadmill
base frame. Connect the CONSOLE CABLE (2) from the
MAIN FRAME (3) to the CONSOLE CABLE (2) in the
bottom of the RIGHT CONSOLE MAST (3). The other
end of the CONSOLE CABLE (2) should be located at
the top of the mast.
E
Attach RIGHT CONSOLE MAST (3) to MAIN FRAME (2)
using 4 BOLTS (A), 4 FLAT WASHERS (C) AND
4 SPRING WASHERS (D)
F
Repeat STEP E on the LEFT SIDE.
NOTE: Be careful not to pinch the console
cable while attaching the right console mast.
NOTE: Do not fully tighten bolts until STEP 3.
A
C
D
B
Publicité
