Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY STEP 2
HARDWARE FOR STEP 2
PART
TYPE
E
HEX SOCKET BOLT
F
FLAT WASHER
G
SPRING WASHER
H
ARC WASHER
5
4
G F
E
H
4
DESCRIPTION
M8X1.25PX15L
8.4X15.5X1.6T
8.2X15.4X2.0T
8.2X18.0X1.5T
E
G
F
2
3
NOTE: Do not fully tighten bolts until STEP 3.
QTY
6
A
Open HARDWARE FOR STEP 2.
4
B
Gently place the CONSOLE (5) on top of the CONSOLE
6
MASTS (3&4). Attach the LEFT SIDE first using 3 BOLTS
2
(E), 3 SPRING WASHERS (G), 2 FLAT WASHERS (F)
and 1 ARC WASHER (H) on the bottom.
C
The CONSOLE CABLE (2) is tucked into the RIGHT
CONSOLE MAST (3). Using the lead wire carefully pull
the CONSOLE CABLE (2) out of the RIGHT CONSOLE
MAST (3). Detach and and discard the LEAD WIRE.
Connect the CONSOLE CABLES (2) and carefully tuck
wires into the right mast to avoid damage.
D
Attach the RIGHT SIDE of the CONSOLE (5) using
3 BOLTS (E), 3 SPRING WASHERS (G), 3 FLAT
WASHERS (F) and 1 ARC WASHER (H) on the bottom.
NOTE: Be careful not to pinch any wires while
assembling the console.
E
G
F
H
11
Publicité
Table des Matières
