Lateral Grass Ejection; Adjusting The Cutting Height; Adjust Front Wheels; Switching On And Off - Grizzly ERM 1851 A Q-360 Traduction De La Notice D'utilisation Originale

Remove mulch kit
4. Lift the impact protection (6).
5. Release the mulch kit (8) by
pressing together the double
grips and then remove it.

Lateral grass ejection

Before using the lateral grass ejec-
tion, the mulch kit (
inserted and the grass collection
box ( 14) has to be removed.
Install lateral ejection canal
1. Lift the lateral impact protection
(11).
2. Mount the lateral ejection chan-
nel (9) and remove the lateral
impact protection (11). It holds
the side ejection channel (9) in
position.

Adjusting the cutting height

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
Hold the cutting height adjuster
(7) and move it to the correct
cutting height, as appropriate.
There are 6 different cutting heights:
25-75 mm
The correct height is around 30 – 45 mm
for a decorative lawn and around
30 –65 mm for a used lawn.
A higher cut height should be
selected for the first cut of the sea-
son.

Adjust front wheels

The lawn mower is extremely flexible
and manoeuvrable thanks to the special
construction of the front wheels.
These are to be adjusted according to the
specific situation as follows:
8) has to be

Switching On and Off

1. The alignment of the wheel is
fixed once the clamping bra-
ckets (28) snaps into place. If
the wheel is desired in another
running direction, lift clamping
bracket to release it. Bring
wheel into new position and
clamping brackets snaps into
place once again.
2. Should the front wheels remain
able to move freely, lift the clam-
ping brackets (28) and do not
place them in the opening, but
rather set them on the plate be-
side it.
The red light above the release
button will illuminate as soon as
the lawn mower is connected to a
power supply.
1. Connect the mains plug (
15) to the extension cable.
2. Make a loop in the end of the
extension cable and suspend
this in the cable strain relief (3).
(See illustration
3. Connect the equipment to the
power supply.
4. Before switching on, ensure that
the equipment is not in contact
with any objects.
5. To switch on, press and hold the
release button (26) on the hand
GB
)
77