Promac SX-824DG Mode D'emploi page 44

piece position. Then push down on the same handle
to tighten. You can also push the vise handle (A)
down first, and then tightening the vise by turning
the rectangular handle (B) clockwise. After finishing
the cut, you can loosen the work piece by turning
rectangular handle only. This True-Lock Vise
System has a 4mm tightening travel when the
rectangular handle is completely opened. There is
only a 2mm tightening travel necessary for normal
metal materials. The operator can tighten the work
piece by pushing down the vise handle (A) with a
certain amount of pressure depending on hardness
of work piece.
7-7.VARIABLE CUTTING ANGLE SELECTION
Please proceed as follows to obtain desired cutting
angle.
The swivel range is from 0° to 60°clockwise.
Before swinging the base, make sure there is
nothing in the way, or any interference.
1. Unscrew out the knob (A) (fig. 7) swing the saw
arm.
Refer to scale on (B) (fig. 7) for degree.
2. Screw out the knob (A) (fig. 7), then start the
cutting.
Fig. 6
7-8.vise for left and right position
Please proceed as follows to obtain desired clamp
vise moving to left and right.
Before moving the vise, make sure there is nothing
in the way, or any interference.
1. Unscrew out the knob (A) (fig.7-1) and push the
vise
2. The handle will be left side when the vise stay in
left side as(fig.7-2 )
3. And push the handle by anti-clockwise until hear
the noise from the vise push the handle
Then the handle will be left side (fig.7-3 )
En 10 / 56
Fig. 7
Fig. 7-1