Promac SX-824DG Mode D'emploi page 48

Bad Cuts (Rough)
Blade is twisting
Saw arm can not Be
raised up after Pushing
the raising Button
7. Blade guide assembly loose
8. Blade truck too far away
from wheel flanges
1. Too much speed or feed
2. Blade is too coarse
3. Blade tension loose
1. Cut is binding blade.
2. Too much blade tension
1.Improper setting of depth
gauge
En 14 / 56
6. Adjust guide space.
7. Tighten
8. Re-track blade according to operating
instructions.
1. Decrease speed or feed.
2. Replace with finer blade.
3. Adjust blade tension.
1. Decrease reed pressure.
2. Decrease blade tension.
1. Press the emergency stop Button and
RESET.
2. Check the upper limit switch and stop
round Position. Make sure the limit switc
is always underneath the stop roun bar.
3. Check the oil gauge; make sure the oil is
in proper range.
4. Check the motor revolution direction;
make sure the motor revolution is in
clock-wise direction.