Promac SX-824DG Mode D'emploi page 43

BEARINGS, CARBIDE BLADE GUIDES AND
BACK-UP BEARINGS AND CLEARING THE
CUTTING CHIP
Before making the following adjustments, make sure
the blade is tracking and tensioned properly:
1. The back of the blade (A) (fig3) should ride
against the back-up block (B) (fig3-1). To
adjust, loosen set screw (C) and move the
guide block (D) up or down, until it lightly
touches the back of the blade .
2. The saw blade (A) should also ride between
and lightly touch the two blade guide roller
bearings (E) (fig. 3)
3. The carbide blade guides (H) (fig 3-1) should
also be adjusted so they lightly touch the
blade by loosening screw (K). and adjust the
screw (F) (fig 3-1) to have right space for
blade
4. The blade guide roller bearings, carbide
guides and backup bearing on holder (fig 9 )
should be adjusted in the same manner.
5. Cutting chips on the blade will be cleared by
the steel brush.
Fig. 3
7-6.OPERATING THE TRU-LOCK VISE SYSTEM
INSTRUCTIONS
To operate, proceed as follows:
1) Raise the arm 2" above the work piece; Put your
work piece on the table. Move the vise handle (A)
(fig. 6) upwards to an angle of 45 degree (a-Half
opened) to loosen the vise. Move the vise jaw
bracket against the work piece by turning the
rectangular handle (B) (fig. 6) for . Push down on
the vise handle (A) to lock the work piece in
position. To loosen the work piece from the vise,
2)
hold the work piece and lift the vise handle (A) (fig.
6) to a 90 degree position (completely opened).
Remove work piece.
3) To fast moving the vise , to push the handle of
(A) (fig. 5).
Then push/pull (B) (fig. 6)
CONTINUED CUTTING:
When you need to cut a work piece many times, just
raise the vise handle (A) to loosen and adjust work
En 9 / 56
Fig. 3-1
Fig. 5