Before First Use - Outdoorchef AROSA 570 G Manuel

EXPLANATION OF THE SYMBOLS ON THE OPERATING CONSOLE
Heat settings/heat levels and Ignition
BURNER SYSTEMS
KETTLE
Barbecuing systems with two ring burners
The large ring burner achieves its highest power at the setting and its lowest power at the
the medium to high temperature range.
The small ring burner achieves its highest power at the setting and its lowest power at the
the medium to low temperature range.
SIDE COOKING PLATE (APPLICABLE ONLY FOR MODELS WITH SIDE COOKING PLATE)
Burner system for the additional side cooking plate
The burner achieves its highest power at the setting and its lowest power at the
OUTDOORCHEF.COM
: off position
: low power
: medium power
: high power
: Ignition
setting. It is designed for applications in
setting. It is designed for applications in
setting.
24

BEFORE FIRST USE

1. Clean all parts that come into contact with food.
2. Check all parts that carry gas, as described in the LEAK TEST section. Also do this if your AROSA 570 G was delivered pre-assembled by
the retailer.
3. Let the barbecue burn for about 20–25 minutes at the
INSTRUCTIONS FOR LIGHTING
KETTLE
1. Make sure that all connections between the gas hose, the gas pressure regulator and the gas bottle are firmly tightened (as described in
the LEAK TEST section).
2. Open the barbecue lid. CAUTION: Never ignite the barbecue when the lid is closed.
3. Open the gas supply at the gas bottle.
4. Press the gas regulating knob of the selected ring burner and turn it anticlockwise to the
knob and hold it until the gas is burning.
5. If the gas does not ignite within 3 seconds, set the gas regulating knob to
Then repeat step 4.
6. If it is not possible to light the barbecue after 3 attempts, look for the causes (as described in the TROUBLESHOOTING section).
SIDE COOKING PLATE (APPLICABLE ONLY FOR MODELS WITH SIDE COOKING PLATE)
1. Make sure that all connections between the gas hose, the gas pressure regulator and the gas bottle are firmly tightened (as described in the
LEAK TEST section).
2. Open the lid of the side cooking plate. CAUTION: Never ignite the side cooking plate when the lid is closed.
3. Open the gas supply at the gas bottle.
4. Press the gas regulating knob for the side cooking plate and turn it anticlockwise to setting
hold it until the gas is burning.
5. If the gas does not ignite within 3 seconds, set the gas regulating knob to
Then repeat step 4.
6. If it is not possible to light the burner for the side cooking plate after 3 attempts, look for the causes (as described in the
TROUBLESHOOTING section).
OUTDOORCHEF.COM
setting.
setting. Press the gas regulating
. Wait 2 minutes to allow the uncombusted gas to dissipate.
. Press the gas regulating knob and
. Wait 2 minutes to allow the uncombusted gas to dissipate.
25