Wiring - SOMFY Sonesse 40 io Notice D'utilisation

Sonesse 40 io
2.1.3. Assembling the drive / tube
1) Slide the drive into the winding tube.
For winding tubes with a smooth interior, position the cut notch on the
crown.
2) The drive wheel must be locked in place to prevent any movement
in the winding tube:
This can be achieved by fastening the winding tube to the drive
wheel using 4 self-tapping screws, Ø 5 mm, or 4 steel pop rivets,
Ø 4.8 mm, placed between 5 mm and 15 mm from the outer edge
of the drive wheel, regardless of the winding tube.
Attention
The screws or pop rivets must only be fastened onto the drive
wheel and not on the drive.
2.1.4. Assembling the tube / drive assembly
Attention
The motorised product must not be compressed between the brackets
If necessary, screw the bracket adapter to the drive head.
Assemble and fi x the drive/tube assembly onto the end bracket (d) and
onto the drive bracket (e).
Attention
Ensure that the drive/tube assembly is secured onto the end
bracket. This operation prevents the tube/drive assembly from
coming out of the end bracket attachment.

2.2. WIRING

Attention
• Cables which pass through a metal wall must be protected and isolated using a sheath or sleeve.
• Secure cables to prevent any contact with moving parts.
• The cable on the Sonesse 40 io cannot be removed. If it is damaged, return the drive to the A er-Sales
department.
• Leave the drive power supply cable accessible: it must be easily replaceable.
- Switch off the power supply.
- Connect the drive according to the information in the table below:
230 V
1 Neutral
2 Live
©
Copyright 2018 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
50 Hz
Blue
Brown
1)
2)
L
e
OFF
1 2
230 V 50 Hz
EN
d
11