Plug Connections; Threading And Feeding Welding Wire - Miller AA40G Manuel Du Propriétaire

Table des Matières

Publicité

5-4. Plug Connections

5-5. Threading And Feeding Welding Wire

Tools Needed:
Pressure
Indicator
Scale
JOG
Push wire thru guide up to drive rolls; continue to
hold welding wire. Press power source Jog push
button until drive rolls grab wire. Adjust tension until
wire does not slip. Indicator is for reference only.
Welding Power Source
ON
PURGE
V
OFF
POWER
JOG
Turn on power at welding power source.
Pressure
Adjust
Press Jog push button until wire comes
out of gun. Feed wire to check drive roll
pressure. Adjust knob enough to pre-
vent slipping.
1
1
2
Cord is available in 30 ft (9.1 m)
length.
3
To make connections, align key-
way, insert plug, and tighten
threaded collar.
2
3
Pull and hold wire; cut off end.
WOOD
Ref. ST-153 072-A / Ref. ST-156 798 / 802 914
Weld Control
Motor Control Cord (Not
Supplied)
Motor/Drive Assembly
803 251-B / 801 443-C
Hold wire tightly to keep it
from unraveling.
6 in
(150 mm)
Cut off wire. Close cover.
OM-200 580 Page 15

Publicité

Table des Matières
loading

Table des Matières