2-6. Plug Connections
2-7. Threading And Feeding Welding Wire
Tools Needed:
Pressure
Indicator
Scale
WIRE ADVANCE
Push wire thru guide up to drive rolls; continue to
hold welding wire. Press Wire Advance push but-
ton until drive rolls grab wire. Adjust tension until
wire does not slip. Indicator is for reference only.
OM-179 082 Page 12
POWER
ON
V
OFF
Weld Control
Welding Power Source
Set switches.
Pressure
Adjust
Press Wire Advance push button until
wire comes out of gun. Feed wire to
check drive roll pressure. Adjust knob
enough to prevent slipping.
1
2
3
WOOD
1
Weld Control
2
Motor Control Cord (Not
Supplied)
Cord is available in 10 ft (3 m),
30 ft (9.1 m) or 50 ft (15.2 m) length.
3
Motor/Drive Assembly
To make connections, align key-
way, insert plug, and tighten
threaded collar.
Ref. 801 440 / Ref. 801 443-A
Hold wire tightly to keep it
from unraveling.
6 in
(150 mm)
Pull and hold wire; cut off end.
Cut off wire. Close cover.
Ref. ST-153 072 / Ref. ST-156 798