Etherma SOLAMAGIC S1 Instructions De Montage Et D'utilisation page 21

is ended by extended pressing of a key on one hand-held trans-
mitter (heating tube extinguishes and restarts for 2 seconds).
Programming
1-10 V interface: To program, briefly press the middle key 5 (the connected ra-
diant heater switches to 33 % heat output), thereafter briefly
press key 5 again (heat output goes to 100%). To complete
programming press and hold the middle key 5 for about 6 s
(heating tube switches off, back on, off again, on and off, only
then should key 5 be released)
Safety
switch-off: The radiant heater always remains switched off after a power
outage.
Reprogramming
Selective
deleting: Already programmed wireless receivers can be deleted and
reprogrammed using the corresponding hand-held transmitter.
To do this, press and hold buttons 1 and 2 of the hand-held
transmitter simultaneously (longer than 3 seconds) until the
red control lamp on the hand-held transmitter illuminates. De-
letion is now enabled. Now release the buttons and immedi-
ately press the button for approx. 1 sec., which the wireless
receiver was operated up until now.
The control lamp on the hand-held transmitter flickers briefly
when the deletion signal is sent. The wireless receivers enter
the on-state and then switch off.
These receivers can now be reprogrammed as described un-
der „Programming" above.
Complete
deletion:
Note:
This action deletes all receivers that are within range of the hand-held
transmitter.
Programmed wireless receivers can also be deleted (reset)
upon loss of a hand-held transmitter or if it becomes defective.
The deletion process is only possible within 180 seconds of
connection to the mains of the receiver in question. (If neces-
sary, disconnect the receiver from the mains and then recon-
nect.)
To delete, hold buttons 1 and 2 of the hand-held transmitter
pressed down (longer than 3 seconds). When doing so, the
red control lamp on the hand-held transmitter only illuminates
once deletion is enabled. Now release the buttons and imme-
diately afterwards press both buttons simultaneously for ap-
prox. 1 sec..
The control lamp on the hand-held transmitter flickers briefly
when the deletion signal is sent. The wireless receivers enter
the on-state and then switch off.
21
08/2017