Operating The Hand-Held Transmitter; Operation Of The Remote Control - Etherma SOLAMAGIC S1 Instructions De Montage Et D'utilisation

Operating the hand-held transmitter

• Initial programming of the wireless remote control is necessary prior to its first
use. Please follow the description in the „Programming" chapter.
Key assignment:
Funkfernbedienung: Transmission frequency: 433.92 MHz

Operation of the remote control

Switching
on/off: Brief pressing of the programmed wireless channel button on
the hand-held transmitter switches the connected radiant hea-
ter on or off.
Short-term
heating: Double-clicking the programmed wireless channel key swit-
ches the radiant heater on for 15 minutes and then automati-
cally switches it off again.
Heating level: Extended pressing of the programmed key on the hand-held
transmitter switches the heat output up and down between
three levels (33, 66 and 100 %).
Memory
function: Upon switching back on, a short press of the key recalls the last
heating level.
Timed switch off: If a timed switch-off has been activated in the programming,
the radiant heater always switches off automatically after the
specified time. The radiant heater signals as follows after the
activating the set residual run time:
Signal duration 2 s
Signal duration 4 s
Signal duration 6 s
Synchronisation: If multiple radiant heaters are controlled using the same hand-
held transmitter button, faults in the wireless transmission
path can result in different states. For synchronisation, use
the function „Heating level" to initially set all radiant heaters
in switched-on state. Then switch off all receivers by a briefly
pressing the key. The „Heating level" function can now be used
to simultaneously set again all the actuated receivers.
Keys 1-4: Wireless channel keys
Key 5: Special key
Battery: CR 2032, 3 volt
Range: approx. 20 m with an unimpeded
path through air
- 30 minutes residual run time
- 60 minutes residual run time
- 90 minutes residual run time
19
1 2
5
3 4
08/2017