Programming The Wireless Remote Control - Etherma SOLAMAGIC S1 Instructions De Montage Et D'utilisation

Programming the wireless remote control

Important: • Only those radiant heaters should be connected to the
mains that are to undergo programming to a hand-held
transmitter button. In this way several receivers can be
programmed for simultaneous operation (multipower).
Already programmed radiant heaters can remain con-
nected to the mains.
• Use of other components with a radio-signal interface
(e.g. wireless PC mouse and keyboard) can result in
faulty operation of the radio receiver. Switch off all
other wireless components, particularly when program-
ming.
• The programming of the wireless remote control is only
possible if there is no jumper (1-10V interface) on WSI.
• The remote control function is disabled when the WSI is
programed on 1-10V interface.
Initial
programming:
(Wireless) The heater to be programmed is connected to the mains. Brief
pressing of the desired key 1 to 4 on the hand-held transmitter
triggers wireless receiver programming (heating tube starts at
low level). Repeated pressing of the same key confirms the
programming (heating tube switches to top level).
If desired, time-out switching can be programmed by doub-
le-clicking: If the programmed key is pressed briefly twice in
succession, the heater will switch off in 30 minutes. The
heating tube activates for 2 seconds. Double-clicking again
increases the heating duration to 60 minutes (heating tube
illuminates for 4 seconds). Double-clicking again increases
the shut-down to 90 minutes (heating tube illuminates for 6
seconds). Double-clicking once more switches the time con-
trol off. The programming cycle for time-out switching begins
again from the beginning. Programming is ended by long pres-
sing of the programmed key of the hand-held transmitter. The
heating tube confirms that programming is completed by ope-
rating for two seconds.
Multiple
programming:
(Wireless) It is possible to program radiant heaters on up to eight keys on
one or more hand-held transmitters (multi-control).
Connect the relevant heaters to the mains. As described un-
der „Initial programming", the key to be programmed is briefly
pressed (heating tube starts at low level) and confirmed through
repeated pressing (heating tube starts at low level). Program
the next key by pressing (heating tube starts again at low level)
and confirm (heating tube starts at low level). This process is
repeated until all the desired buttons on all the desired hand-
held transmitters are programmed. The multiple programming
20