GYS AUTOPULSE 220-M3 Mode D'emploi page 28

DEFINITION OF THE INTERFACE SYMBOLS
Step backwards or cancellation.
To validate the settings and to display the welding window.
To choose the display mode and the main parameter.
To access the job menu (program management).
To use the selected program.
Removal of the selected program
Mode Indicates the welding mode, the trigger mode but also the material and the gas.
1
Left wheel rotation.
2
Right wheel rotation.
Welding position.
Flat position
Angle position
Trigger mode (2T, 4T, Spot, Delay).
Wire diameter.
Couple: Material-Gas.
Setting the thickness to be welded.
Setting the electronic induction.
Setting the arc length.
Chart mode (level, duration, arc length).
OVERVIEW OF INTERFACE LEVELS
1/ Menu and settings
28
AUTOPULSE 220-M3
This section allows to set the welding mode (Manual, Standard, Pulsed or Pulse In
Pulse)
In Standard mode, pulsed and pulse in pulse mode, it is possible to select the trigger
mode, wire diameter and the couple material-gas.
EN