The Expert and Advanced modes give access to the
welding cycle.
The advanced mode is used to set the arc voltage at
each welding cycle.
5/ Pulse In Pulse mode
In Pulse in Pulse mode, the left window allows to
access the main parameter and the right one to the arc
length.
Expert mode and advanced mode allow to access the
welding cycle.
AUTOPULSE 220-M3
In 4T mode, the Hotstart, pre gas, crater filler and post
gas can be controlled through the trigger.
The second window of the simple mode allows to access
the welding position and to the self.
In 4T mode, the Hotstart, pre-gas, crater filler and post-
gas can be managed by the trigger.
EN
31