GYS AUTOPULSE 220-M3 Mode D'emploi page 60

Masquer les pouces Voir aussi pour AUTOPULSE 220-M3:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SPÉCIFICATIONS TECHNIQUES / TECHNICAL SPECIFICATIONS / TECHNISCHE DATEN /
ТЕХНИЧЕСКИЕ СПЕЦИФИКАЦИИ / TECHNISCHE GEGEVENS / SPECIFICHE TECNICHE
Primaire / Primary / Primär / Первичка / Primaire / Primario
Tension d'alimentation / Power supply voltage / Stromversorgung / Напряжение питания / Voedingsspanning / Ten-
sione di alimentazione
Fréquence secteur / Mains frequency / Netzfrequenz / Частота сети / Frequentie sector / Frequenza settore
Fusible disjoncteur / Fuse / Sicherung / Плавкий предохранитель прерывателя / Zekering hoofdschakelaar / Fusibile
disgiuntore
Secondaire / Secondary / Sekundär / Вторичка / Secondair / Secondario
Tension à vide (U
)* / No load voltage (U
0
lastspanning / Tensione a vuoto (U
Courant de sortie nominal (I
ток (I2) / Nominale uitgangsstroom (I2) / Corrente di uscita nominale (I2)
Tension de sortie conventionnelle (U
Условное выходные напряжения (U2) / Conventionele uitgangsspanning (U2) / Tensione di uscita convenzionale (U2)
Facteur de marche à 40°C (10 min)* Norme EN60974-1.
Duty cycle at 40°C (10 min)* Standard EN60974-1.
Einschaltdauer @ 40°C (10 min)* EN60974-1 -Norm.
ПВ% при 40°C (10 мин)* Норма EN60974-1.
Inschakelduur bij 40°C (10 min)* Norm EN60974-1.
Ciclo di lavoro a 40°C (10 min)* Norma EN60974-1.
Vitesse de moteur / Motor speed / Velocidad de motor / Скорость двигателя / Snelheid motor / Velocità del motore
Fils supportés / Supported wires / Alambres/hilos soportados / Подходящие виды проволоки / Onders-
teunde draden / Fili supportati
Bobines supportées / Supported wire reels / Bobinas soportadas / Подходящие бобины / Ondersteunde spoelen / Bobine
supportate
Pression maximale de gaz (Pmax)
Type de galet / Drive roller type / Drahtführungsrolle-Typ / Tipo de rodillo / Тип ролика / Type draadaanvoerrol /
/ Tipo di rullo
Température de fonctionnement / Functionning temperature / Betriebstemperatur / Рабочая температура / Gebruikstempera-
tuur / Temperatura di funzionamento
Température de stockage / Storage temperature / Lagerungstemperatur / Температура хранения / Bewaartemperatuur /
Temperatura di stoccaggio
Degré de protection / Protection level / Schutzgrad / Степень защиты / Beschermingsklasse / Grado di protezione
Dimensions (Lxlxh) / Dimensions (Lxlxh) / Abmessung (LxBxH) / Размеры (ДхШхВ) / Afmetingen (Lxlxh) / Dimensioni (Lxlxh)
Poids / Weight / Gewicht / Вес / Gewicht / Peso
*Les facteurs de marche sont réalisés selon la norme EN60974-1 à 40°C et sur un cycle de 10 min.
Lors d'utilisation intensive (> au facteur de marche) la protection thermique peut s'enclencher, dans ce cas, l'arc s'éteint et le témoin
Laissez le matériel alimenté pour permettre son refroidissement jusqu'à annulation de la protection.
La source de courant décrit une caractéristique de sortie de type plate.
Dans certains pays, U
est appelé TCO.
0
*The duty cycles are measured according to standard EN60974-1 à 40°C and on a 10 min cycle.
While under intensive use (> to duty cycle) the thermal protection can switch on, in that case, the arc stops and the indicator
Keep the machine's power supply on to enable cooling until the thermal protection switches off.
The machine has a specification with a "dropping current output" in MMA and with a "constant current output" in MIG/MAG.
In some countries, U0 is called TCO.
*Einschaltdauer gemäß EN60974-1 10min - 40°C.
Ein Überschreiten der Einschaltdauer) kann zur Aktivierung des Überhitzungschutzes führen. In diesem Fall wird der Lichtbogen ausgeschaltet und die Kontrollleuchte
Lassen sie das Gerät bis zum Erlöschen der Warnleuchte eingeschaltet.
Die Stromquelle besitzt im MMA-Modus eine fallende Ausgangkennlini und im im MIG/MAG-Verfahren eine flache.
U0 = TCO.
*Los ciclos de trabajo están realizados en acuerdo con la norma EN60974-1 a 40ºC y sobre un ciclo de diez minutos.
Durante un uso intensivo (> que el ciclo de trabajo), se puede activar la protección térmica. En este caso, el arco se apaga y el indicador
Deje el aparato conectado para permitir que se enfríe hasta que se anule la protección.
La fuente de potencia posee una salida de característica descendente en proceso MMA y de tipo plana en MIG/MAG.
En algunos países, U0 se llama TCO.
*ПВ% указаны по норме EN60974-1 при 40°C и для 10-минутного цикла.
При интенсивном использовании (> ПВ%) может включиться тепловая защита. В этом случае дуга погаснет и загорится индикатор .
Оставьте аппарат подключенным к питанию, чтобы он остыл до полной отмены защиты.
Источник питания имеет выходную характеристику «падающего типа» в режиме ММА и «плоскую характеристику» в режиме MIG/MAG.
В некоторых странах U0 называется TCO.
*De inschakelduur is gemeten volgens de norm EN60974-1 bij een temperatuur van 40°C en bij een cyclus van 10 minuten.
Bij intensief gebruik (superieur aan de inschakelduur) kan de thermische beveiliging zich in werking stellen. In dat geval gaat de boog uit en gaat het beveiligingslampje
Laat het apparaat aanstaan zodat het kan afkoelen, totdat de beveiliging afslaat.
De vermogensbron beschrijft een dalende uitgangskarakterstiek in MMA en een vlakke uitgangskarakteristiek in MIG / MAG.
In sommige landen wordt U0 aangeduid met TCO.
*I cicli di lavoro sono realizzati secondo la norma EN60974-1 a 40°C e su un ciclo di 10 min.
Durante l'uso intensivo (> al ciclo di lavoro) la protezione termica può attivarsi, in questo caso, l'arco si spegne e la spia
60
Lasciate il dispositivo collegato per permettere il suo raffreddamento fino all'annullamento della protezione.
La fonte di alimentazione genera una caratteristica di uscita di tipo discendente in MMA e costante in MIG/MAG.
In alcuni Paesi, U0 viene chiamata TCO.
AUTOPULSE 220-M3
)* / Leerlaufspannung (U
0
)*
0
) / Normal current output (I
) / nominaler Ausgangsstrom (I
2
2
) / Conventional voltage output (U
2
)* / Напряжение холостого хода (U
0
) / Номинальный выходной
2
) / entsprechende Arbeitsspannung (U
2
s'allume.
switches on.
se enciende.
si illumina.
AUTOPULSE 220-M3
230 V -20% +15%
50 / 60 Hz
)* / Nul-
0
10  220 A
) /
14.5  25 V
2
20%
60%
100%
0.5  20.0 m/min
Fe
ø 0.6  1.0
ø 0.8  1.0
Inox
ø 0.8  1.2
Al
CuSi / CuAl
ø 0.8  1.0
ø 200 mm
0.5 MPa (5 bars)
-10°C  +40°C
-20°C  +55°C
90 x 63 x 92.5 cm
leuchtet.
branden.
1~
16 A
80 V
220 A
150 A
130 A
B
IP21
69 kg

Publicité

Table des Matières
loading

Table des Matières