Costan NC5xSyD Mode D'emploi page 27

Modello - Modèle - Model
Modell - Modelo - Modelo
Fabbricante - Constructeur - Manufacturer
Hersteller - Fabricante - Fabricante
Authorized Service Centre.
CAUTION: the refrigeration system is High Pressure. Do not tamper with the system and
contact a qualified, specialized
technician before disassembly.
CAUTION: maintenance should be carried out only by qualified personnel.
Children should be supervised to ensure they do not play with the unit.
CLEANING THE DISPLAY CASE
1) Every week clean the outer surfaces of the display case with mild soap or detergent in
lukewarm water only. Wipe carefully with a soft cloth. Never clean it using inflammable or scouring
agents, alcohol, acetone or solvents.
NEVER CLEAN THE DISPLAY CASE BY THE USE OF WATER JETS. Clean glass surfaces using glass-
cleaning products exclusively. The use of water is not recommended here, as it may cause scale to
build up.
CAUTION! NEVER WASH OR CLEAN THE UPPER PART OF THE DISPLAY CASE WITH WATER OR LI-
QUIDS
2) Every month clean the inside surfaces following the instructions provided in the preceding
item:
3) Clean the condenser at least every 30 days with a hard non-metal brush, removing dust
and dirt from between the fins. Condenser fan is not protected. Make sure that the cabinet is
switched off before starting cleaning operation. The condenser is on the roof of the cabinet. A soiled
condenser cools less, so causing energy wastes and poor performance. Wear heavy-duty gloves
when cleaning the condenser (fig. 21-22 on page 13). When taking the cabinet out of service, di-
sconnect the power supply and follow the steps above, but leave the doors open to avoid foul odour.
4) Defrost the display case every three months to let the ice that may have formed between
the fins melt. Frost may otherwise prevent correct operation. Proceed as follows.
· Disconnect the display case from the electrical power supply by the wall main cut-off switch (fig.
19).
· Empty the appliance, store the contents in cold rooms or refrigerators that are adequate for kee-
ping the requisite preservation temperature.
· Wait until the cold room has reached ambient temperature.
· Clean the inside of the display case thoroughly with mild soap or detergent and lukewarm water.
Wipe carefully with a soft cloth.
· After having carefully checked that the display case is completely dry inside, start the appliance
again by the wall cut-out switch.
· Allow a couple of hours before loading the products back again.
Attention! Disassemble and assemble very slowly, using heavy-duty gloves. It is advisable to have
these cleaning operations carried out by authorized service personnel.
Attention! Disassemble and assemble very slowly, using heavy-duty gloves. It is advisa-
GRANBERING INTEGRAL
NC5xSyD
Epta Spa - Unità locale: Via degli Alpini 14 - 32020 Limana (BL)
ITALIA Tel. 0437/9681 Telefax 0437/967434
Condenser fan is not protected. Make sure that
the cabinet is switched off before starting cleaning
operation
27/45
PAGE:
UM000329
N° DOC.