Removing The Naída Ci From The Clip; Using The Naída Ci Sound Processor; Powering The Naída Ci; Removing The Battery - Advanced Bionics Naida CI Q70 Mode D'emploi

Masquer les pouces Voir aussi pour Naida CI Q70:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 35
5
Depress the spring end of the clip to open
and secure the sound processor to the
desired location on clothing or in hair.
Removing the Naída CI from the Clip
1
To disengage the Naída CI processor
from the clip, first pull back the
release tab that is helping to hold the
processor in the clip.
The processor should come out of the clip with the battery still attached to the processor. It is
recommended that the T-Mic 2/Earhook be removed from the Naída CI before wearing the
processor completely off the ear. Please see
Using the Naída CI Sound Processor
Powering the Naída CI
Power supplies and battery chargers should be operated in an open area
CAUTION:
to ensure adequate airflow. While, todate, no injuries have been reported, components
may become hot during normal use or in the event of a fault.If the device's temperature
results in discomfort or pain when touched, disconnect the power source and contact
your local AB representative.
22
Naída CI Sound Processor User Guide
2
Carefully remove the Naída CI, leading
with the internal earhook portion. Be
careful not to use the PowerCel as a lever
to remove the Naída CI; this may damage
the PowerCel or the connector on the
Naída CI.
Removing the T-Mic 2/Earhook.
The processor is turned 'on' when a charged battery is attached to the processor. In order to
power 'off' the processor, the battery cartridge must be removed. When the battery is engaged
the orange LED located in the middle of the volume control will flash to indicate battery charge
followed by the green LED to indicate program position.
The Naída CI will always power on in Program 1 with the volume and sensitivity at the default settings.
To power down the Naída CI, simply remove the battery cartridge.

Removing the Battery

1
Rotate the RF cable upward to avoid
bumping it upon battery removal.
3
Firmly slide the battery cartridge away
from the Earhook or T-Mic 2.
2
Hold the sound processor in one hand. In
the other hand hold the battery cartridge.
4
Continue sliding the battery cartridge until
it separates from the processor.
23
Naída CI Sound Processor User Guide

Publicité

Table des Matières
loading

Table des Matières