Wearing The Naída Ci; Using The Clip; Inserting The Naída Ci In The Clip - Advanced Bionics Naida CI Q70 Mode D'emploi

3
Continue turning until the T-Mic 2 Cover
separates from the T-Mic 2. Discard used
T-Mic 2 Covers.
It is recommended to use the T-Mic 2 only when the T-Mic 2 cover is
CAUTION:
properly seated. The T-Mic 2 cover should be replaced every 3-4 months or if plugged
by earwax.
Wearing the Naída CI
The Naída CI has been designed with flexibility in mind. The processor was built to the smallest
size possible for user comfort when worn on the ear without compromising performance.
Recipients also have the option to wear the processor completely off the ear, using the clip, or
partially off the ear with the power source removed from the processor and securely attached
elsewhere on the recipient's body. These designs ensure the most comfortable, secure, and
discreet wearing options possible. Naída CI cables come in a variety of lengths and colors
which recipients can change to suit their preference. This section describes a variety of wearing
options for the Naída CI.
The Naída CI processor can be worn in a variety of locations depending on the recipient's
age and preference. Some Naída CI wearing locations may obscure the sound processor LED;
therefore, internal alarms may be helpful to notify adult wearers of processor status. Internal
alarms can be activated by your hearing care professional.

Using the Clip

Front View
20
Naída CI Sound Processor User Guide
*Enlarged view
Rear View
The Naída CI Clip comes in left and right configurations to provide improved wearing flexibility
and the ability to wear the processor in a secure, completely off-the-ear style. This need is
particularly great for small children and many physically active CI users.
The Naída CI Clip is intended to attach directly to clothing, hair or in the preferred wearing
location. There are both left and right sided clips to suit the recipient's preference.
The Naída CI Clip fits all three sizes of PowerCel rechargeable batteries, as well as the Zn-
Air Battery Pak. The clip also includes a silicon cover for added protection when the T-Mic 2/
Earhook is detached.
Inserting the Naída CI in the Clip
1
Hold the sound processor in one hand
and the clip in the other hand.
3
Release
Latch
Gently but firmly push the processor into
the clip so the portion of the processor that
goes over the ear (ear side) slides down
into the clip. This portion of the processor
is held in place by a release tab.
2
Align the processor so the button side
goes into the back of the clip opening
first, making sure the retention arm lies
between the volume control and the
program button.
4
If the earhook/T-Mic 2 has been
removed, secure the silicon cover
in the opening that would typically
contain the earhook/T-Mic 2.
21
Naída CI Sound Processor User Guide