Lenz Digital plus SILVER+PluX12 Mode D'emploi page 34

34
28 Bit RailCom configuration
1 (0)
1
2 (1) 1
Bit
29 Settings 1
1 (0) Direction of travel
0
1
2 (1) Running-notches mode:
0
1
3 (2) Operational mode:
0
1
4 (3) 0
1
5 (4) 0
1
6 (5) 0
channel 1 release for address broadcast
channel 2 release for data and command acknowledge
normal: locomotive drives forward if the arrow on the manual
control points up.
interchanged: locomotive drives forward if the arrow on the
manual control points down.
Operation with 14 or 27 running notches.
This setting is chosen for digital systems which do not
support the 28 running-notches mode.
Operation with 28 or 128 running notches.
This setting is chosen for digital systems which support the
28/128 running-notches mode.
Locomotive only runs in digital operation.
Locomotive runs both in digital and conventional operation,
flying splice possible.
RailCom transmission disabled
RailCom transmission enabled
factory pre-set speed curve is used
User defined speed curve is used
Decoder uses basic address (from CV1)
Information SILVER+PluX12 Decoder
3(dec)
1
1
6 (dec)
0
1
1
0
0
0