Lenz Digital plus SILVER+PluX12 Mode D'emploi page 26

26
2 Installing the SILVER+PluX12 (Abb. 1)
These decoders come with a 12-pole plug. This plug makes the installation of these decoders very
simple. To install the decoder simply remove the dummy plug in your locomotive and install the
decoder plug. When installing the plug ensure that the pins are not bent or broken.
3 Testing the installation
Place the locomotive on the programming track (without its housing) and read the address. The
decoder is programmed ex-works to the address 03. If you have connected the decoder correctly
thus far, you should now be able to read the address. If you are not able to do so, it is possible that
you have made a mistake when connecting the cables. Do not subject the locomotive to full running
track power until you obtain the correct "03" address read-out. Check the cable connections and
change them as required. You should now be able to send your locomotive on its first test run on
your layout.
4 Features of the decoder
The following contains a short survey of the features of the GOLD+ decoder as well as information
on how to set them.
You can find detailed information on the features and their settings in the "Manual Plus
Decoders" that you can download from the Lenz Elektronik GmbH website
www.lenz-elektronik.de/pdf/download.php
4.1 Capacity and protection equipment
The motor output has a current-carrying capacity of up to 750 mA even without special installation
on cooling surfaces! The short-term maximum current-carrying capacity is 1.0 A. The function
outputs have current-carrying capacities of 500 mA each.
Information SILVER+PluX12 Decoder