Normal Operation - SATA paint set 10 Mode D'emploi

Operating Instructions SATA FDG
9.3. Motor driven agitator
Fatal risk of electrocution
There is a risk of severe to fatal injuries when carrying out installation
and maintenance work with live voltage.
→ Before working on the electric agitator, disconnect the electric voltage
and protect it from being reconnected unintentionally. Only connect the
electric motor to power circuits that can be disconnected with an all-
phase power switch.
■ Connect the electric agitator to the power circuit as stated in the en-
closed documentation.

10. Normal Operation

Fatal risk from exploding material pressure tank.
The build-up of static electricity when operating the tank can cause
sparking with the risk of the material pressure tank exploding.
→ Ensure that the pressure tank is adequately earthed.
→ Ensure a bleeder resistance of < 1 MOhm.
→ Only use approved, conductive hoses.
10.1. Agitators
Hand agitator
The hand crank [5‑1] / [11‑1] can be used to agitate the material by hand.
Pneumatic agitator
Damage from incorrectly conditioned compressed air
Incorrectly conditioned compressed air can damage the pneumatic mo-
tor.
→ The pneumatic motor must be operated with technically clean, oiled
compressed air. The oil rate is approx. 1 drop acid-free oil per minute.
Warning!
Warning!
Attention!
EN
173