14-Pin Plug Information; Wire Type, Size, And Feed Speed Capability Table - Miller D-74S Manuel Du Propriétaire

5-4. 14-Pin Plug Information

J A
K
I
B
L
H N
C
M
G D
F
E
*The remaining pins are not used.

5-5. Wire Type, Size, And Feed Speed Capability Table

Motor Speed Wire Type
Standard All
Standard All
Standard All
Optional High
All
Speed
Notes
OM-1500-6 Page 18
.
A complete Parts List is available at www.MillerWelds.com
Pin*
A 24 volts AC with respect to socket G.
B Contact closure to A completes 24 volts AC contactor control circuit.
G Circuit common for 24 volts AC circuit.
C +10 volts DC input from power source to wire feeder with respect to socket D.
D Remote control circuit common.
E 0 to +10 volts DC output signal from wire feeder to power source with respect to socket D.
H Voltage feedback; 0 to +10 volts DC, 1 volt per 10 arc volts.
F Current feedback; 0 to +10 volts DC, 1 volt per 100 amperes.
Wire Size
.023 To 5/64 in. (0.6 To 2 mm)
3/32 To 7/64 in. (2.4 To 2.8 mm)
1/8 in. (3.2 mm)
.023 To 5/64 in. (0.6 To 2 mm)
Pin Information
Rated Speed Range (per IEC 60974-5)
55 To 770 ipm (1.4 To 19.6 mpm)
55 To 700 ipm (1.4 To 17.8 mpm)
55 To 300 ipm (1.4 To 7.6 mpm)
92 To 1435 ipm (2.3 To 36.4 mpm)
Work like a Pro!
Pros weld and cut
safely. Read the
safety rules at
the beginning
of this manual.