Section 7 − Maintenance; Routine Maintenance - Miller D-74S Manuel Du Propriétaire
Masquer les pouces
Voir aussi pour D-74S:
- Manuel de l'utilisateur (40 pages) ,
- Manuel d'utilisation (36 pages) ,
- Manuel de l'utilisateur (36 pages)
Table des Matières
Publicité
7-1. Routine Maintenance
3 Months
Replace
unreadable
labels.
Replace
cracked
parts.
6 Months
Blow out or vacuum
inside. During heavy
service, clean
monthly.
Notes
OM-1500-6 Page 24
.
A complete Parts List is available at www.MillerWelds.com
SECTION 7 − MAINTENANCE
Clean and
tighten
weld
terminals.
Check
14-pin cord.
Or
!
Disconnect power before maintaining.
Repair or
replace
cracked
weld
cable.
Check gas
hose and
fittings.
Clean
drive rolls.
Work like a Pro!
Check gun
cable.
Pros weld and cut
safely. Read the
safety rules at
the beginning
of this manual.
Publicité
Table des Matières
