How To Use; Adjusting The Lift Of The Presser Foot - JUKI SC-922 Mode D'emploi

(5) How to use

1) When the pedal is in the neutral position, press the knee switch or lightly depress the back part of the
pedal, and the presser foot can be raised as long as you keep either of them held depressed.
2) The presser foot automatically goes up after thread trimming, and the presser foot is lowered by de-
pressing the front part of the pedal to allow the machine to start sewing. Presser foot can be lowered by
depressing the knee switch once and returning it to the home position or depressing the back part of the
pedal and returning it to the neutral position.
Knee switch

(6) Adjusting the lift of the presser foot

DU-141H-7, DSU, DSC
❶
A B
❷
Sewing machine
DU-141H-7 Lift of the intermediate presser
DSU series Lift of the intermediate presser
DSC series Lift of the feeding frame
(For the LZH-1290-7, the lift of the presser is set to 15 mm.)
1) Loosen adjusting nut ❶ and turn cylinder rod ❷ to adjust so that the
lift of the relevant presser foot is set to the aforementioned values
when the cylinder is fully retracted. turn in direction A to decrease
the lifting amount or in direction B to increase it.
2) After the completion of the adjustment, tighten adjusting nut ❶ .
– 10 –
High speed
Low speed
Stop (neutral)
Presser foot lifting
Thread trimming
Part to go up
Lifting amount
(mm)
15
13
13