JUKI SC-922 Mode D'emploi page 29

3) Check first that the sewing-machine connectors have been removed. Then, place the sewing machine
controller in the setting where the sewing machine stops with its needle down. Loosen setscrew ❷ of
synchronizer ❶ . To adjust so that the sewing machine stops with its needle down, turn the joint to align
engraved marker dot ❹ on the handwheel which represents the lower position (i.e., the sewing machine
stops with its needle down) with engraved marker dot ❸ on the machine arm.
The location of the engraved marker dots on the handwheel which represents the stop position of the
sewing machine differs with model. Refer to List 3 for the location of the marker dots of your sewing ma-
chine.
4) After adjusting DOWN stop, set the sewing machine controller to the needle UP position setting and con-
firm the UP stop position. When UP stop position is improper, perform fine adjustment with UP position
detecting plate ❺ .
5) After adjusting the stop position, attach the cover of synchronizer ❶ . Return the sewing machine control-
ler to the needle DOWN position setting.
List 2
Model
LU-2200N series
DU-141H-7, DSC series, DSU series, LZH-1290-7
List 3
Model
DU-141H-7, DSC series, DSU series
LZH-1290-7
LU-2200N series
■ How to set the needle bar position when the machine is stopped
Make the setting by function No.10 (needle bar position setting when the machine is stopped).
1) Refer to "1. Setting of the mounted head, 1) How to enter into the function setting mode" and enter into
the function setting mode.
switch ❸ or
2) Press
switch ❺ or
3) Press
"0"....down position stop, "1".....up position stop
4) After the setting is made, press
Upper-position
marker dot
Red
Between red and red
Between F and E
❸ ❹ ❺
switch ❹ to call out function setting No.10.
switch ❻ and select "0" or "1".
switch ❸ or
– 3 –
Scale of DOWN position detecting plate ❼
A
D
Handwheel
Lower-position
maker dot
White
White
K
❻
switch ❹ , and turn the power OFF.
Reverse-rotation
needle-up position
marker dot
-
-
B