Operating The Log Splitter - Power Fist 8893539 Manuel D'utilisateur

V4.0
OPERATION
PRE-INSPECTION
Before each use inspect the log splitter's components for damage or wear.
Component
Hoses
Hydraulic fittings
Nuts and Bolts
Beam
Moving Parts

OPERATING THE LOG SPLITTER

CAUTION! Do not force the log splitter for more than 5 seconds to split hard
wood. This may damage the tool. Rotate the log 90 degrees and attempt
again. Discard the log if unable to split, as it exceeds the splitting force
capacity of this tool.
NOTICE! The log splitter does not ship with hydraulic oil in the tank. Fill and
bleed the hydraulic system per Care and Maintenance instructions to avoid
damaging the log splitter.
1. Cut the log down to a height of 20-1/2 in. or less to ensure that it will fit
between the wedge and the beam platform.
2. Cut narrower logs in a horizontal position and wider logs in the vertical
position. To change the position:
a. Loosen the lock assembly (F) and pull down on the handle (J) to raise
the beam to the horizontal position or push the handle up to lower the
beam to a vertical position.
b. Tighten the lock assembly to keep the beam in place.
3. Place the log onto the beam (A) and bottom platform.
4. Reposition the log on the beam platform so the wood grain is aligned with
the wedge. Ensure that the log is stable on the log guides (E) and properly
Visit www.princessauto.com for more information
12 Ton 3-Position Log Splitter
Problem
Inspect for exposed wire mesh and leaks. Replace all worn or
damaged hoses before starting engine.
Inspect for cracks and leaks. Replace all damaged fitting
before starting engine.
Check for loose bolts. Tighten any that are found.
Apply grease to beam surface
Clear debris
8893539
13