Assembly & Installation - Power Fist 8893539 Manuel D'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

V4.0
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
Letter references in parenthesis (A) refer to the included Identification Key.
Dashed numbers in parenthesis (Fig. 1-1) refer to a specific point in an
illustration or image.
LOCK & HANDLE ASSEMBLY
1.
Place the body frame assembly
upright on the ground.
2.
Attach the handle (#22) to the end of
the beam. Slide a spring washer (#9)
and washer (#10) over an M10 x 16
bolt (#23). Repeat with three more
bolts. Insert each bolt through a
handle bolt hole and screw the bolt
into the beam until secure.
3.
Attach the handle bar (#73) to the lock
plate (#12) with an M6 x 10 screw
(#72). Use the bolt hole to the side of
the lock plate opening.
4.
Slide the bolt hole at the end of the
lock plate over the beam's top bolt.
Secure with a washer (#10) and M10
lock nut (#11).
5.
Place the lock handle (#36) over the lock shaft (#33). Align the bolt holes
in each. Slide an Ø8 washer (#35) over the M8 x 40 bolt (#34) and insert
the bolt through the bolt holes in the handle and shaft. Secure with an M8
lock nut (#37).
6.
Slide the Ø37 x Ø14 x 3 washer (#32) over the lock shaft (#33). Position
the lock metal plate opening over the body frame's bolt hole. Screw the
lock shaft into the bolt hole.
Visit www.princessauto.com for more information
12 Ton 3-Position Log Splitter
8893539
Fig. 2
9

Publicité

Table des Matières
loading

Table des Matières